Distributor Opportunities:
Online Warranty Registration:
Demos for sale:
Click below for:
Available Distributor Opportunities
Click below for:
Warranty Registration
&
Predelivery Check List
online.
Click below for:
Available Demo Hoists
for sale.
home
new products
features/benefits
models
accessories
photo gallery
warranty
testimonials
for sale
company history
hooked on quality
tradeshow info
contact Us
distributor login
Predelivery Check List
Swaploader All Model Hoist Installation
Conducted By:
*
Date:
*
Dealer:
*
Customer:
*
I. SwapLoader Hoist INFORMATION:
SwapLoader Model No.:
*
Hoist Serial No.:
*
Truck Chassis
Make:
*
Model:
*
GVW:
*
Distance from rear of cab to the Center Line of Rear Axle/Tandem (CA):
*
Distance From Center Line of Rear Axle/Tandem to Rear of Hoist (AF):
*
PTO
Make:
*
Model:
*
Serial No.:
*
% of Engine RPM:
*
Hyd. Pump
Make:
*
Model:
*
Serial No.:
*
II. INSTALLATION TO CHASSIS:
Were there any problems installing the hoist to the truck chassis?:
Yes
No
*
If yes, please describe in full:
*
All bolts checked for proper tightness?
Yes
No
*
III. CONTROLS:
Controls easy to reach from driver's seat?
Yes
No
*
Movement of controls correct per installation instructions?
Yes
No
*
IV. HYDRAULICS INSTALLATION :
Correct hydraulic oil level in reservoir?
Yes
No
*
Check for leaks?
Yes
No
*
Any abnormal noise during operation?
Yes
No
*
If yes, explain :
*
With engine operating @ 1,000 RPM, record the following information:
Cycle time for dump mode:
Up:
Sec.
*
Down:
Sec.
*
Cycle time for
load/unload mode:
Unload:
Sec.
*
Load:
Sec.
*
Filter Pressure:
PSI
*
Main pressure, controls
in neutral:
PSI
*
Main relief pressure extending jib Cylinder (Bottomed out):
PSI
*
Main relief pressure extending lift cylinders (Bottomed out) :
PSI
*
*Note: Connect pressure gauge to fitting provided on inlet section of Hyd. Control Valve (Ref. Pt. No. 10P37 fitting on Hyd. Pump Circuit Drawing found in the Parts List section of the Hoist Operations Manual).
V. OPERATION
Jib operates freely in both directions?
Yes
No
*
Can Jib be extended or retracted when raised in dump position or when pivot joint is tilted in unload position?
Yes
No
*
Both safety hooks are fully engaged when jib is extended?
Yes
No
*
Correct hydraulic oil level in reservoir Parts and operators manual in cab?
Yes
No
*
Have sliding jib and all grease zerks been lubricated per install instruction?
Yes
No
*
VI. DECALS
Have all safety decals and product decals been installed per enclosed decal drawing? Can be found attached to the inside of the hoist operations manual cover or at the back of the parts list section of the hoist operations manual.
Yes
No
*
Additional comments.
:
